Electric CNC metal gear Fuel pump

Specifications:

1.Voltage:  4.8V-6V

2.Flow Rate:  1000CC/min

3.Delivery Lift:  0.8M

Features:

1. All-metal movement, long service life;

2. Fully enclosed motor design, high safety;

3. Fully shielded metal case, no interference;

4. Positive and negative rotation design, it can pump and can be pumped;

5. Low voltage and high efficiency only use 4.8v battery pack;

6. With Mounting Bracket can be fixed with screw or cable ties;

7. Sealed with Polyurethane, Nitro and gasoline can be used;

Attention:

1. Gear Pump is a precision high-speed rotating equipment., so please make sure the liquid pumped is clean. Impurities will be stuck in pump, causing the motor overheat or damage the gear, so please install filters in the pipeline.

2. Do not idle a long time, and do not pump high temperature liquid, to avoid       excessive wear of the metal pump and the gear;

3. Please use the 4.8-6V battery pack, higher voltage will do nothing but make the pump heat, the increase of the pump flow rate is limited;

4. This gear pump is designed for fuelling model, do not use on other occasions.

5. The fuel pipe must be connected to fuel tank firstly, and then power on the pump to work.